How to make a MEDUZA Synth in Serum?
Here is our step by step instruction:
STEP #1
- Use the default waveform for OSC A
- Activate OSC B and select the bipole_harmonic waveform
- Put both OSC one octave lower and add 6 voices
- Slightly decrease the level of OSC A
STEP #2
- Decrease the sustain of ENV 1 to about -5.0dB and extend the release to about 3.00s
- Activate the filter for OSC A & B and reduce the cutoff to 110Hz
- Connect ENV 1 with the cutoff filter (drag)
- Halve the cutoff range
STEP #3
- Add a compressor, activate multi band mode and increase the gain to 12dB
- Add an EQ, set the low EQ type to LPF and decrease the Q a bit
- Set the high EQ type to peak, set the free to about 1800Hz, keep Q at 50% and reduce the gain to -8dB
- Add chorus behind that, set mix level to 100%, depth to 17ms and feed to 20%
STEP #4
- Go to ENV 2 and set the sustain to 20%, extend the decay to 2.80s
- Reduce the chorus LPF to 330Hz, connect it to ENV 2 and shrink the range to 30
STEP #5
- Add a delay at the end of your effect chain, select ping-pong mode and set left to 1/8 and right to 1/4
- Set the feedback to 60% and mix level to 40%
- Add a reverb to the end and increase the mix level a bit
STEP #6
- Add a brightwhite NOISE and activate the NOISE in the filter section
- Reduce the NOISE level and connect it with ENV 2
- Halve the range of the NOISE level
THAT'S IT!
---
